Ernie Ball Volume and Wah Pedals presented by Analog Man
The design and development of the Ernie Ball pedals has been a team effort of guitar players and craftspersons. Pedal bodies are an aluminum extrusion rather than a casting resulting in greater strength, uniformity, and smoother surfaces. Clear anodized grain finish insures lasting beauty. Overall dimensions: 4" W x 11" L x 2.5" H. The main pivot shaft is of centerless ground 1/2' diameter stainless steel, precision seated though nylon bushings at both ends. The large center shaft diameter, in addition the strength factor, creates a broader stress bearing surface. Our bodies and shafts are designed to give the player an indefinite service life! Deck mat of non-slip material is impervious to oil, alcohol, and most things you might spill on it. Quick disconnect wiring harness allows changing the pot without soldering. Tough long lasting Kevlar cable transmits pedal travel to the controls and is attached by stainless steel springs. This drive design results in smooth and quiet operation qualities lacking in gear driven models. Cycle tests are made on every pedal to insure perfect operation prior to packaging.
If your pedal ever wears out after years and years of use, you can send it to Ernie Ball for a complete rebuild. They will replace every part except the case, for a reasonable charge. There is a 6 month warrantee on these pedals.
For easy ordering, check out our new website buyanalogman.com . The new website uses a shopping cart for everything so it's very easy to buy multiple items or add in options. It allows using paypal in addition to several other payment methods including credit cards. It also keeps track of status, tracking numbers, etc and allow editing orders after they are placed so it's best to use our new website.
Volume Pedal
The potentiometer has a 250k ohm resistance suitable for the
audio path of passive instruments. Will work great with both Humbuckers
and single coil guitars. Behind the jack area under the
footplate is a taper switch, which provides the user two distinct
volume swell rates. A tuner output is provided and allows silent
tuning when the pedal is in the heel down position.
Product Number: 6166
Volume Pedal / Switch
The potentiometer has a 250k ohm resistance suitable for the
audio path of passive instruments. Behind the jack area
under the footplate is a taper switch, which provides the user
two distinct volume swell rates. A tuner output is provided and
allows silent tuning when the volume pedal is in the heel down
position. Attached to the footplate is an on/off switch connected
to the jack labeled "Switch". This is an isolated
circuit and may be used for controlling other gear in your system
like amp channel switching, effects bypass, etc.
It does not turn the volume pedal OFF.
Product Number: 6168
Stereo Volume / Pan Pedal
The dual potentiometer has a 500k ohm resistance suitable for the
audio path of passive instruments. Attached to the footplate is a
switch that provides the user two operating modes (volume or pan).
Use the A input / A output for the left channel and the B input /
B output for the right channel for stereo signals. For use with
stereo cable installations using TRS type stereo plugs, use the B
input and B output. For use as a mono volume pedal, use the A
input and A output. For use as a typical pan pedal, switch the
toe tap switch to the pan position and use only the A input. The
pedal will pan the signal between the A and B outputs.
Product Number: 6165
VP Junior 250K
See buyanalogman.com for more info.
For easy ordering, check out our new website buyanalogman.com . The new website uses a shopping cart for everything so it's very easy to buy multiple items or add in options. It allows using paypal in addition to several other payment methods including credit cards. It also keeps track of status, tracking numbers, etc and allow editing orders after they are placed so it's best to use our new website.
return to Analog Man